News

Easy Guide For Changing Hydraulic Cylinder

Update:Feb 12, 2019
Summary:

Many times, a hydraulic cylinder in your car can be rep […]

Many times, a hydraulic cylinder in your car can be repaired by changing out pistons or seals inside the cylinder. However, on rare occasions, you may need to replace the entire cylinder itself. If that situation arises, you will need to know how to correctly remove the old hydraulic cylinder and install a new one. This easy-to-follow how-to guide will show you to do just that.

 

(Note - In most cases, if you order an entire cylinder assembly from the car manufacturer or other aftermarket parts maker, the cylinder will come with seals and pistons included. Therefore you should not need to disassemble the cylinder.)

 

First, disconnect the negative battery cable from the terminal post on your car's battery.

 

Jack up your vehicle and place it on jack stands, so that you can work with the hydraulic cylinders and on your vehicle.

 

Depending on your vehicle, the hose may be held to the cylinder using clips or clients. However, in most cases, you'll be able to remove the clamps with a crescent wrench or other small wrench. Remove the screw from the clamp that holds the clipper clamped in place and disconnect the hose.

 

Remove the bolts that hold the hydraulic cylinder in place.

 

Place a plastic bucket or container underneath the cylinder and hoses to catch the hydraulic fluid that may drain out. Then, hold the cylinder upside down in order to drain the remaining fluid into the bucket or plastic container.

 

Take an old rag or towel and wipe the area where the cylinder was installed to remove any major dirt or grime in the area.

 

Use the bolts that were used to hold the hydraulic cylinder in place when installing the new cylinder. Be sure to apply a sufficient amount of torque to the bolts to ensure that they won't work loose when the vehicle is being driven.

 

Connect the hydraulic hose to the cylinder. Then, push the clamp or clip up to the end of the hose so that it can hold the hose in place. Tighten the screw or bolt that locks the clamp or clip.

 

Locate the fill plug on the cylinder and remove it. Fill the cylinder to the fill line. Be careful not to fill the cylinder too much as this may cause an increase in the pressure of your vehicle's hydraulic system. Too much pressure could cause damages to hoses or other components in your car.

 

Remove the jack stands and use the car jack to lower the vehicle.